This is a three-part component system that uses a fabric mesh, resin and a resin activator to create artificial nail coatings.

What’s in the fibreglass system?

Tejido de malla

The fabric in this system provides a reinforced structure, acting like the polymer beads in the liquid monomer and polymer powder system, blocking cracks from spreading. Typically the fabric mesh is fibreglass or natural silk mesh. There are slight differences between the two, fibreglass doesn’t absorb the resin as well as the silk which is why silk mesh is less visible. Fibreglass is slightly stronger as it stays as fibreglass and does not soak up the resin. The fabric mesh is needed as the resin when it polymerises does not form cross-links to other polymer chains, meaning it is slightly weaker on its own, which is why the mesh is used to provide additional strength and durability.

Resina

Although referred to as resin, this component is actually a cyanoacrylate. There are various types on the market, some are thick gels, others thinner. Cyanoacrylate bonds strongly with the nail plate and is also used as nail adhesives and for adding nail tips to nails. This family of acrylates cure when exposed to moisture in the air.

Cyanoacrylates themselves rarely cause allergic reactions however there are additional chemicals within their formulations that may cause adverse skin reactions.

The resin breaks down quickly in water and in acetone, due to its chemical structure.

Activador de resina

As mentioned above, the resin starts polymerising when exposed to moisture in the air. An activator is used to speed up the process and to ensure a proper cure, either a spray or brush-on is used.  When using a spray be careful and cautious, normally only a tiny amount of activator is needed; too much can cause a heat spike.  A brush on activator produces a slower but more controllable cure.

Precauciones y problemas con el sistema de fibra de vidrio

Este sistema no es tan fuerte como los otros sistemas pero aún así puede producir grandes resultados especialmente en uñas cortas o con clientes que no son demasiado duros con sus uñas.  

Al tratarse de una formulación diferente a la de los otros sistemas, puede ser adecuada para clientes que hayan desarrollado sensibilidad a otros sistemas. 

El uso excesivo del aerosol activador puede provocar un doloroso pico de calor; por lo general, sólo es necesaria una pulverización muy corta a 30 cm de la uña.