Câu hỏi:
There is a new trend of putting acrylic under full coverage tips the question is can the acrylic fully cure under the tip? No air can get to it so can polymerization fully complete without the evaporation of any excess monomer? How do the ends of the polymerized chains complete? Do they fully react to heat or is air needed? Thank you for your consideration my colleagues and I together hold a rather large audience on tic tok and do not want to give out information that could lead to allergies. Or dermatitis.
Trả lời:
Câu trả lời này thể hiện suy nghĩ logic của tôi về câu hỏi này.
Oxy ức chế quá trình trùng hợp (do đó có lớp dính trên bề mặt gel được xử lý bằng tia UV). Không có lý do gì để nghi ngờ kỹ thuật này sẽ gây ra bất kỳ vấn đề nào khác ngoài việc rò rỉ tiếp xúc với da.
Many UV gel brands are using this as a new system but none of the L&P brands is which, to me, would suggest they are not confident in the success of it.
Monomer does not need to evaporate. If the ratio is correct then it should all be used up in the polymerisation. It is only when the ratio is wrong that some are left over to get trapped in the coating.
I hope this helps. My suggestion is don’t try to be a chemist. listen to the trusted manufacturers.
